Replacing copper sleeve cone crusher

Copper sets is an important component of the cone crusher, such as copper eccentric shaft sleeve, moving cone copper sleeve and the horizontal axis copper sets, during operation of the device plays a very important role, let's look at the cone crusher copper sleeve Replace.

Replace the eccentric shaft sleeve of copper

After locking filler hole drilling broken, then rewind the eccentric sleeve, copper sleeve can be removed. Before installing new copper sets, you must check whether the eccentric sleeve hole size cracks. When installing copper eccentric shaft sleeve, cooled with dry ice available. When pouring locking filler, eccentric and copper sleeve must be at a temperature of about 70 degrees, eccentric copper sleeve hole must be positive.

Replacing copper moving cone sleeve

Moving cone copper sleeve can be cut out, but make sure not to damage the dynamic cone bore. Moving cone copper sleeve can be directly drawn out, it can be cooled with dry ice to speed up the pull-out speed. Dry Ice is available when installing the moving cone brass sleeve, each need at least 2 hours when fully cooled after, with its rings to lift copper sleeve, from under the rings to use flat gaskets to ensure copper sleeve edges and the bottom edge of the movable cone parallel.

Replace the horizontal axis of the copper sleeve

Outer copper sheath can be removed by pulling device made within the copper sleeve can be removed using a center rod means hammering out the copper sleeve split out, you need to check the inner shaft holder hole size is reasonable. When installing the horizontal axis copper sets, use a dry ice shrink at least 2 hours.